|
-----------------------------------------------------------------------------------Tape
Top Edge Of This Page To 14 Inch Side Of
Box------------------------------------------------------------------------
|
 ©
Metallic Finishing System for Flying Scale Models
For The Look Of The Real Thing
7–1/2”
by 5–1/8” by 14–3/8” Dispensary Box
|
|
|
|
|
A
<-
CAREFULLY
FOLLOW ASSEMBLY DIRECTIONS BELOW
->
A
|
|
DO NOT CUT OUT PERIMETER OF
RULER AREA |
|
B
B
|
|
DO NOT
CUT OUT PERIMETER OF RULER AREA |
|
|
1: Tape
top edge of this page
centered to
14 inch side of Flite-Metal box
after removing
roll of Flite-Metal from package.
2: Center ruler along inside edge of
area “A”. Cut along ruler edge with a
hobby knife and remove “A” gray
shaded area being careful to make smooth
straight cuts .
3: Place enclosed plastic ruler over
area “B” with top edge
centered and
along bottom edge of cut out “A”.
Center ruler and find one of two round
holes, place sharp
point of hobby knife through hole making single 1/4
inch tall vertical slit through box. Place brad
blades through ruler and vertical box slit.
Pull blades through then
with opposite hand against brad button on outside of
box, spread blades in opposite directions
within box interior.
4: Place loose roll of
Flite-Metal “C”
back inside box with
free edge extended about 4 inches through
slot “A” shiny side up
then tape box
end closed.
5: To dispense properly, pull
desired length of Flite-Metal from box, cut
along ruler edge with hobby knife
being careful not to cut yourself with the
sharp knife
blade. |
|
|
|
|
 |
|